Vision TC3 VGATP VGA over Cat5e/Cat6
TC3 VGATP Part of Visions Techconnect Twist product family, the TC3 VGATP Carries VGA signal over CAT5e cable up to 60m (80m with CAT6) the Audio loops through on the input plate module. Audio is not carried over the CAT5 cable and the Power adapter can be used at either end.
The TC2-VGATP transmitter presents as a normal Vision Techconnect VGA and mini-jack module from the front, allowing tidy clip-in installation.
Up To 60m
VGA signal is weak which limits cable length. The VGATP overcomes this and can send 1024 x 768 resolution signal through standard unshielded CAT5e cable up to 60m long. Using CAT6 cable extended the maximum length to 80m.
Audio is presented by means of a pass though 3.5mm stereo jack socket on the front of the input module, this can be wired from the rear of the module direct back to an amplifier. (Audio is not carried over the cat5/6 cable from the input plate to the VGATP receiver)
Proprietary power-over-Ethernet technology means only one mains power adaptor is required to power both the transmitter and receiver. The included international power adaptor can use used at either end.
Replacing VGA cable with a twisted pair cable means if in the future you need to replace the VGA with HDMI or DisplayPort you can just change the adaptors at the ends. Faster Installation Installers can take advantage in buildings which have been flood-wired with network cable. Where a CAT5 cable is already in place the installation is super-fast. EQ An equalisation adjustment pot on the receiver allows for varying cable length.
Recommended Maximum Cable Lengths:
CAT5e: 1024 x 768: 60m / 1280 x 1024: 50m / 1600 x 1200: 40m CAT6: 1024 x 768: 80m / 1280 x 1024: 70m / 1600 x 1200: 60m
Easier To Work With
Compared to VGA cable CAT5 is much less expensive and is easier to work with it has a tighter bend-radius, is thinner, easier to pull, and simple to terminate
Note: Vision TC2 VGATP does not support the SCL and SDA lines which carry's Display Data Channels (DDC) or the related Extended Display Identification Data (EDID) data.
Power Supply: 100/240v AC 50/60Hz External Power Supply – integrated transformer/plug type. DC Output 12V 0.5A, DC Cable 1.8m. Transformer Dimensions: 62 x 42 x 22 mm Interchangeable prongs including UK, EU, AU. Note: a normal figure-8 cable can be plugged into the transformer if preferred.