Vision TM-1200 Universal Projector Mount Bracket
The Vision TM-1200 Projector ceiling mount kit has been designed to fit 99% of all small to medium sized data projectors including: Epson, Hitachi, Sony, NEC and many more.
Vision Techmount TM-1200 can be quickly assembly into a number of different configurations, including flush mount where the projector is as close to the ceiling as possible and the The TM-1200 universal projector mount pole has greater rigidity than a telescopic mount and it can be cut it to length on site so it has an infinitely variable length.
TM-1200 Is Universal:
Cut to any length, Suitable for most Small and Medium sized projectors, suitable for sloping roofs, suitable for very low roofs including Portable Cabins Etc.
TM-1200 Has A Tilting Adapter:
Allows the Tilting of the universal projector mount to a full 90 degrees.
TM-1200 Is Safety Approved:
In line with best practice the Vision Techmount TM1200 projector mount comes with a safety fall-arrest tether which can be used to secure the projector to the bracket and the TM-1200 mount has been Independently tested on calibrated test equipment measured a breaking-strain of half a ton! Vision recommend a maximum safe working load of 10kg which is well within limits.
TM-1200 Is Easy To Install:
The Vision TM-1200 universal projector spider bracket to the projector is simple, most projectors have threaded inserts in the bottom of the projector for attaching to a projector bracket or mount and Not all projectors use the same diameter screws so Vision provide a selection to suit almost all projectors.
TM-1200 Has Cable Management:
Cables can easily be routed from the mounting plate and through the pipe for a nice clean tidy installation.
Finish the job properly:
Enhance aesthetics with the retro-fit trim disk which can be installed after the projector is mounted to the ceiling, ideal for false-ceiling environments and through plasterboard ceilings to properly finish off the projector installation.
The Vision TM-1200 projector mount bracket comes completes with a spanner and pin-hex keys. The only tool you’ll need is a hacksaw or 2″ pipe cutter (ask your tool supplier for a cutter with a 6-67mm range, and a metal file).
Vision have also included with the projector mount pole a drilling jig so that you can easily and accurately drill 9mm holes into the projector pole. Quick-release mechanisms make life easier for thieves, so the Vision Techmount TM-1200 projector mount features pin-hex key security bolts.
1 x H50 Pin-Hex key
1 x 17mm Spanner
4 x M2.5 43mm pan slot for Optoma & Acer
4 x M3 43mm screws
4 x M4 43mm screws
4 x M5 43mm screws
4 x M6 43mm screws
4 x M8 50mm Ceiling Fixtures with rawl plugs
1 x Safety Tether