Vision TC2-CTL3 IR / RS232 AV Controller
**** Not Compatible with TC3 Range ****
Vision TC2-CTL3 + Downloadable Controller Software for advanced programming features makes this one of the most simple and flexible professional AV RS232 and IR control system device available.
A simple yet elegant and very flexible control panel device the TC2-CTL3 can be programed to replicate and control just about any device that has an IR receiver or RS-232 Control including Projectors, Projector screens, TVs, DVDs and Amplifiers and just about any other type of devices that can be operated by Infra-Red or RS-232 control and will only present the users with the functions they need or use every day. No tech support calls, No losing remote controls and self contained in a secure wall mounted unit.
Remotes are all too often lost, stolen or just simply mislaid and in most instances a manufactures replacement remote is not all ways readily available, cheap or easy to find which often results in the the equipment not been used. Installing a Vision Techconnect TC2-CTL3 can resolves all these problems.
Simple Programming Mode
For single button command programming i.e.. controlling just one device like a projector, hold down the two center buttons on the TC2-CTL3 to put Control3 into learn mode, press the button on the TC2-CT3 that you want to program, point the original device remote at the front of the Control3. and press the button you want to learn. Button 2 “Off” is pre-set to send the code twice for projectors, and the bottom buttons 5 and 6 are preconfigured to send codes repeatedly when held down to replicate the function of a volume control.
Advanced Programming Mode
Connect the TC2-CTL3 directly to a PC and use the free downloadable software (Documents Tab) to allocate up to 3 x RS-232 or 3 x IR codes or 3x 12v trigger commands or a mixture of all three types of command to be programmed individually to each of the 6 buttons. Commands for each button can be sent simultaneously, sequentially, or repeatedly if you hold the button down.
Clear caps unclip off the buttons from the front to allow label changes. A set of printed labels are included or you can Download the Vision TC2-CTL3 custom button template from the "Documents Tab" to create and print your own custom TC2-CTL3 button labels.
Other TC2-CTL3 features include:
I.R. (Infra-red) Control
RS-232 and 485 Protocol Control
Pre-Printed button Labels
Piggy Back 2 x CTL3 Units for 6 Button Control
12v Trigger for RF controlled Screens
Mains Powered (Transformer Included)
Battery Powered (limited Functionality)
Note: RS-232 and 485
These two protocols use the same codes but RS-485 only requires two cables and can be run a longer distance. Note: a projector with an RS-232 port will not be able to decode RS-485 signal.